Best Way To Remove Broken Headphone Jack From Ipad

2 Remove the inner piece with the ink in it ink cartridge.

Best way to remove broken headphone jack from ipad. After that slowly push the bare end of the swab into the jack and spin it to brush off the sides of the jack and dislodge any debris. Insert the toothpick or paperclip into the socket until it touches the headphone jack. GripperX Headphone Plug Extraction Tool with Key Ring and Cleaning Brush - Remove Broken Headphone Plug from Headphone Jack of Mobile Devices 33 out of 5 stars 140 1499 14.

Its not very risky to neither the broken jack nor the 35 mm jack but a minor risk persists to the user as you could get yourself pricked so watch out. If it doesnt remove the staw slowly with the jack facing the floor and then take a pair of tweezers and grab the part that has already slipped out and pull it out carefullyIts cheap and fast and worked for. Dry off with a dry part of the thin microfiber cloth.

Headphone jack has broken off in iPhone 3G headphone socket location. Wait for it to cool for a few minutes. Try using a toothpick.

Sometimes dirt and dust can get caked on and require a little more to remove it from the port requiring an implement. As quickly as you can shove the tip of the straw into the headphone port tightly so that it can form around the broken tip of the headphone jack. This will absorb any moisture that was left behind.

5 Once you have it all the way down pull up slowly and the broken jack should slide out. If the tiny post has a corresponding socket on the headphone jack where it separated just put the superglue inside the hole. A tiny tiny amountjust enough to get the end of the post and maybe spill over to the sides a smidge.

If the broken jack piece left in the ipad still has a small post of metal showing mine did i took a short length of wire from a piece of 103 electrical wire ground wire is bare copper took a small soldering gun as it heats up quickly put some soldering flux on the end of the copper wire heated it and put a light coating of solder on it then put a small dab of flux on the broken jack end in. 4 Push it down as far as it will go to try and get the ink cartridge plastic around the broken jack. Do a little alcohol on the microfiber cloth to clean the headphone connector.