How To Solder Auto Wiring

With the soldering done it is time to give your 3-way wire joint a final inspection.

How to solder auto wiring. Run the solder over the entire splice so it can melt and travel into the gaps between the wires. At some point over the next 2-10 seconds depending on how hot your iron is the wires will be hot enough to melt the solder. Its vital to use a soldering iron that brings the wire up to temperature quickly.

Be sure to remove all of the damaged wire section. Hook them together end to end and flatten the Us with the pliers. Place the soldering iron on the exposed pieces of copper for three to five seconds.

Some say its better to crimp them others only twist the wires. Twist the broken wire around the new wire and wrap it toward the new wire insulation. Request a Quote Today.

Once cool inspect the union to ensure proper penetration of the solder. The most reliable way of joining two wires together is by soldering. Keep the soldering iron on the bottom of the wire to continue heating it.

In short when selecting solder wire it is better to use a good reputation and a regular solder manufacturer to supply it will be more secure. My old soldering iron. When buying solder wire remember not to be cheap.

The wires will begin to heat up. Request a Quote Today. It helps to start the heat transfer by dabbing the solder at the point where the iron and wires meet then move the solder to the top.