How To Use A Soldering Heat Gun

Its ciu 21673814-9 There are stuff that are connected to board with a lot of pins.

How to use a soldering heat gun. This was done only to de. Once the soldering iron is hot press it against one section of the wires to start heating it up. You dont want to be inhaling that stuff.

Heat Guns allow you to concentrate the heat onto a targeted area or surface also give you control using the on and off trigger. To add a single new component to the board first place some solder paste on the component. To add a single new component to the board first place some solder paste on the component.

Tin foil for a heat shield for use with heat guns. You only need a little heat to burn right through some repairs. Weve created another soldering video.

But even then it is more reliable to solder the wires and then slide heat shrink over it. Watch the solder to turn shiny to show that its flowing You can then remove the parts using tweezers or needle nose pliers. Ive used a heat gun to heat my banger before but dabbing directly on the soldering iron does not seem like a good idea especially if there is left over solder on it.

Saying the magic spell meltum meltum meltum move the nozzle back and forth until the solder begins to flow the solder should appear shiney and molten. 3M makes ones that are acceptable. Put plumbing flux on the pipe and slide it into the fitting.

The holder is used for gripping or holding the gun. After heating the area. At the higher end 400 to 800 degrees it can thaw frozen.