How Do You Solder Two Wires Together

The aim is to coat the wire with a thin layer of solder.

How do you solder two wires together. The process will form a. To do this follow these steps in order. This simultaneously melts the solder and shrinks the sleeve.

Also I would cover the resulting joint with a piece of heat-shrink tubing before deploying it in the field. Step 7 Remove the wires from the vise when they have cooled and using the needle-nose pliers twist the two soldered wires together to form an initial bond. A simple solution if you dont have a soldering iron handy is to use heat shrink solder sleeves.

Heat the copper and apply solder to the side opposite the heating implement. Use nothing but 60-40 rosin-core solder intended for electrical wiring. Obviously these should not be connected to a power source at the time.

Electrical components placed on a circuit board dont need much prep work. I will be using a power probe butane soldering gun. Mechanical connectors which physically clamp the wires together or to a common conductor are the easiest but they take up more room and particular kinds are prone to failure.

I will show you how to solder wires together the right way to seal the solder joint with heat shrink is a must and you also need to make sure you do not have a cold solder joint. Hold the wires together in one hand and use your free hand to twist the free ends. Pass one wire in each end so that they cross over in the solder ring then simply apply a heat gun.

Youll also need some PVC shrink tube. Connecting two wires can be done with a wire stripper and electrical tape but to make a proper connection you should solder them together or at least use wire nuts. Just get wheel collars that are the appropriate size.