How To Solder Copper Wire

Clean the wire and use a suitable soldering flux.

How to solder copper wire. Solder the wire to the jumper using a moderate amount of solder. Once the solder begins to melt onto the copper move the heat onto the stainless steel. Touch the tip of the soldering iron to the copper wires.

Strip the wires to be cleaned. Nickel is commonly used at operating temperatures over 250 C and provides. The first step in any successful solder joint is to clean the surfaces to be soldered.

How to Solder Stranded Wire to Solid Wire Cut the two wires to be soldered together to the appropriate length as needed for your project. Strip off about 1 inch of the insulation from each end of the two wires using the wire strippers. Again its better to touch the wire against the lead and track on the board rather than the irons tip.

Plug the soldering guniron into an electrical outlet and allow it to heat up for about three to five minutes. Repeat this process on the other wire. Hold the tinned tip of the soldering against the lead and board.

Jumper You can solder to a bare jumper on the circuit board. Once the coppers temperature reaches the melting point of the solder it will liquefy that solder wire which is being held against the copper and it will start flowing into the joint. While nickel-plated conductors offer excellent resistance to high.

This is an acid-free solder that contains a flux in the core of the solder. The other solution is Sodium Bicarbonate or baking soda and water. Plug in your soldering iron to let it heat up and put on all the necessary safety gear.