How To Clean Soldering Iron Without Flux

While it can be useful in certain situations it is not enough to remove oxidation from a soldering iron tip.

How to clean soldering iron without flux. The mixture works on both resin and non-resin based flux as well as no-clean flux too. This can work as a flux of sorts and will allow soldering of copper or aluminum parts that you. Once clean and shiny perform tinning and now your tool is ready to use.

To use the Tip tinnercleaner heat the soldering iron. Always wear gloves before you handle the ethyl and isopropyl solutions and start mixing them. Then dip into the tin of tinner cleaner with a slight twisting action.

To prevent damage to the board you should re-solder your soldering iron now and then as the technique will remove solder from it. The best alternative to flux when soldering is petroleum jelly which is anti-corrosive and will not damage your material. You also can clean your soldering iron tip with a sponge while using it to keep it clean.

It will make your soldering iron long-lasting. The flux will be activated by the heat that will start a chemical reaction to eliminate the oxidation. It will even shine a tarnished penny before your eyes.

Then dip the tip in the cleaner and do a slight twist action. Yes solder can be used without flux. In a pinch you can use a solution of white vinegar and salt.

Its something of a vi-vs-emacs war about which is better but whatever. Emptying the desoldered part and cleaning off the circuit board. If you need to so some very small spot-work though you could get away without the flux but be aware it will likely bead up and roll around the wire instead of stick.