How To Solder Wires Together With A Soldering Iron

The best method showing how to easily solder wires together with no soldering iron.

How to solder wires together with a soldering iron. First you need to strip the wires then add your heat shrink tubing physically connect the wiressolder the wires together and then shrink that heat shrink tubing to make a waterproof connection. The flame of the torch will give off enough heat to solder wires together. Remove the soldering iron and wait a few seconds for the solder joint to cool and harden.

Place tip of soldering iron at the middle of the connection to activate the flux. Tools need will be a soldering iron heat machine rosin flux solder 3M silicone dielectric grease wire s. The simplest kind of soldering is just connecting two wires together.

Remove the soldering iron and wait a few seconds to let the soldered connection cool and harden. Move the iron to the opposite bottom side of the connection and repeat the same technique. You simply touch the freshly tinned tip of your soldering iron onto the bare wires for a couple of seconds and then apply the solder at which point it will smoke and flow over the wires almost immediately and you can withdraw the solder and then the iron and you should be left with a bright silver joint like the one below.

Add the proper amount of solder into the connection. If you are soldering wires strip the insulation off the ends of the wires to be soldered together. Get the liquid solder filler into the wire tip.

If you cannot afford the nichrome wire buy just a gas torch for less than 10 from the local hardware store. In this way the melted solder will get into the header. This process should melt the solder and coat both wires evenly.

Hold the two tinned wires on top of each other and touch both wires with the soldering iron. The process for soldering 3 wires together is the same as splicing 2 4 or even 10 of them. At first take the solder near the male header and slightly touch the solder with the soldering iron.