How To Solder Wire Properly

And allow the solder to melt.

How to solder wire properly. This process should melt the solder and coat both wires evenly. How to Solder Neatly and Properly. Touch the tip of the soldering iron to the wires and keep it there.

Now that your wire has been properly tinned it can be soldered to the sensor the same way as the connector below. Then add some solder until the wire is soaked with solder. How to Solder Copper Wires Correctly.

Note that the wire will get hot so you should consider holding it with some tweezers or similar. Wrap one or two inches of solder around the tip while the iron is cold. When done properly you have a strong conductive connection that turns two separate wires into one.

The solder wire is then applied to the front side of the terminal but is not brought into contact with the iron See figure 1. The process of soldering is taking two or more wires and joining them together and then using heat to melt electrical solder connecting those two wires permanently. The solder should become liquid.

Keep the iron in place and touch the solder to the wire until its fully coated. The reason the iron is placed on the backside and the solder wire to. Learn How to Solder Correctly.

Use the magnifying glass as help if necessary for a closeup view. At some point over the next 2-10 seconds depending on how hot your iron is the wires will be hot enough to melt the solder. Soldering Two Wires.