How To Solder Solid Copper Wire
Cut the two wires to be soldered together to the appropriate length as needed for your project.
How to solder solid copper wire. Thoroughly sanding and scuffing the pipe ends will ensure that you get a solid and leak-proof joint when you go to solder. Jumper You can solder to a bare jumper on the circuit board. Get as much solder as will stick on the part to be joined before its laid flat against the PCB.
Get the liquid solder filler into the wire tip. At first take the solder near the male header and slightly touch the solder with the soldering iron. Apply heat to the wire to warm up the connection.
AND USE NON-CORROSIVE FLUX. A jumper is a stiff sometimes bare wire that bridges across some traces on the top or bottom of the board. Ad Wholesale Mobile Accessories Parts Electronics With 12 years Experienced Supplier.
The trick to soldering is making sure that the joint is fully heated through and not a cold-solder joint. How to Solder Stranded Wire to Solid Wire. Then on the opposite side where the heat is applied apply the solder to the wires.
Hold the solder to the joint you are trying to solder. This will heat the wire to allow your solder to melt. Cut the two wires to be soldered together to the appropriate length as needed for your project.
Strip off about 1 inch of the insulation from each end of the two wires using the wire strippers. You can do this tinning part in two ways. Use the properly sized wire brush and clean the copper pipe fittings inside socket area.