How To Solder Guitar Pickup Wires

Skip the center lug for now and solder a wire from Lug-3 to the back casing of the Volume pot.

How to solder guitar pickup wires. Touch the solder to the tip of the iron the. Just reverse the and ground leads on the GFS pickup without disturbing the silver shield. Then dip the repair in hot wax and let it dry.

2 Next remove the jack plate from the guitar the cover is often held in place by two small screws. Resist the temptation to blow on the solder to hasten the process. Use the pliers to hold the wire in place and remove the iron.

If you are looking for solder for guitar components then you probably should pick up something with a rosin core. Then go back to winding. You can also bend the lug back and solder it directly to the casing if you prefer.

Solder the Ground wire and the bare wire if you have one to the back casing of the Volume pot with Lug-3. Do use a soldering stand to hold your soldering iron so you wont burn yourself or your guitar. 3 Avoid trimming excess wires coming off your.

3 Locate the loose wires and double check to make sure the connection problem is from the wires. Take a look at Fig 1. To do this solder a wire to the bridge pickup and then connect that wire to the potentiometer.

Repeat this process several times during the first few minutes of its life and your soldering tip will last longer and conduct heat better. This will re-insulate the wires. Bring the wire to the back of the pot and hold it in place with the soldering iron.