How To Remove Broken Headphone Piece From Ipad

If you are using the device that has the broken piece in it simply turn on the captions by clickin.

How to remove broken headphone piece from ipad. If the broken jack piece left in the ipad still has a small post of metal showing mine did i took a short length of wire from a piece of 103 electrical wire ground wire is bare copper took a small soldering gun as it heats up quickly put some soldering flux on the end of the copper wire heated it and put a light coating of solder on it then put a small dab of flux on the broken jack. Apply moderate pressure while drilling about 34. Ive had to do this three times and its very tricky.

Success without any damage to my oh so addicting iMac 27 As always I used this site to get ideas. Do not open up the laptop yet. Put the burr into your Dremel tool make sure the burr sticks out far enough to reach all the way into the jack opening and set your Dremel on its lowest speed.

IPad Stuck In Headphone Mode after. Sep 4 2012 1302 151 MA. Used pin straightened tool to free the edges of the headphone male jack from the female internal jack.

IPad Headphone jack broken inside iPad. Thanks iFixit you are amazing. There was a small piece i yanked at to get it out because it was above the surface but only that piece came out.

I tried tweezers already the hole is too small for it. Now half of my headphone jack is stuck in my ipad and I cant get it out. Used the smallest probe to pull the stuck piece forward.

My warrenty for it is out and if I go try to get it fixed at an Apple store they will most likely tell me. I have been using the Intuit GoPat card scanner for credit card processing on my ipad. The scanners jack has broken off into the headphone jack and I am unable to remove the broken piece.