How To Properly Solder Wires

How to Solder a Circuit Board and PCB Board.

How to properly solder wires. Fold over the wire connection. When properly soldered the connection should be smooth and shiny. Lastly put Solder on the wire especially on the tip.

Be able to solder most small electronic components and small circuits together yourself. Moreover soldering wires to the contact pads of the printed circuit board. So soldering of two overlapping wires.

The trick to soldering is making sure that the joint is fully heated through and not a cold-solder joint. Apply enough solder so that every strand of wire is surrounded by solder. At some point over the next 2-10 seconds depending on how hot your iron is the wires will be hot enough to melt the solder.

Apply Solder Flux to the Wire Joint. The wires will begin to heat up. Slide the heat shrink tube over the junction and apply heat with a heat gun.

Lock and Firmly Twist the Stripped Wires Together. Cut the wires to the. Once the connection evenly turns the correct silver color of solder remove the soldering iron and allow the joint to cool.

And then hold the soldering iron for 3-5 sec unless the Solder is melted. Examples of where soldering is applicable to this class is the joining of wires on a circuit board of wires to a module or wires to other wires to name a few. Make sure to heat it before because of that the Solder melts and joints with the connector.