How To Properly Solder Electrical Wires

This will help conduct heat to the wire.

How to properly solder electrical wires. Some say its better to joint the two wires using a Y-splice while some only swear by the good ol rat tail splice. Wrap one or two inches of solder around the tip while the iron is cold. Hold the two tinned wires on top of each other and touch the soldering iron to both wires.

This article will show you the proper way on how to solder wires together. Use heat shrink to cover the connection. The trick to soldering is making sure that the joint is fully heated through and not a cold-solder joint.

Tarnished copper is hard to solder. Apply Solder to the Wire. Apply Solder Flux to the Wire Joint.

Now measure cut and solder a wire from the top right potentiometer to the bottom right one. Now that your wire has been properly tinned it can be soldered to the sensor the same way as the connector below. Do not over tin the wire or solder may flow up under the wires insulation causing it become rigid or you will end up with globs of solder on the terminal that will have to be removed.

Take your solder and touch at the point where the iron and wire make contact. How to Solder Wires Together Correctly Like a Pro. Before touching the soldering tip to the wires tin the tip by melting a small amount of solder on it.

Repeat this process on the other wire. Soldering to component sockets or element pins. Lock and Firmly Twist the Stripped Wires Together.