How To Prepare A Soldering Iron Tip

Wipe the iron on a damp sponge to remove the excess.

How to prepare a soldering iron tip. To prevent this you use solder to protect it. Plug in the iron and switch it on. After a minute or two the iron should be hot enough to steam when touched to the sponge.

If you are taking good care of your soldering iron it would last longer than usual. Start by sanding the cracked surface to restore its shape. This process will help improve the heat transfer from the iron to the item youre soldering.

Iron again which means adding a fair amount of solder and letting it. I havent used the hard-way tip yet Then I dipped the tip halfway into flux wrapped it up in high-tin solder. Use set screws to re-assemble the iron.

Then dip into the tin of tinner cleaner with a slight twisting action. Again the easy tip was made into a screw at one end of the brass rod screwed into the soldering iron and then cut off of the rest of the rod. Turn on the soldering iron and set temperature above the melting point of your solder.

It also minimizes exposure beyond the surface of the tip. Sit for a few minutes before wiping it clean. It was also polished shiny.

Before you can start soldering you need to prep your soldering iron by tinning the tip with solder. After soldering check the solder joints carefully. When it comes to the sponge cleaning method be sure to use de-ionized water to prevent contamination as well as a sponge specially-rated for soldering so it is sure to withstand the high temperature.