How To Make Soldering Wire

You can solder any metal objects together even wires to other wires.

How to make soldering wire. This type of terminal barrel lends much better to crimp-then-solder than do pre-insulated terminals. Making a soldering litz wire is of as following. Repeat this process on the other wire.

Hold the two tinned wires on top of each other and touch the soldering iron to both wires. You should not apply too much solder. If you are soldering a USB30 internal connector you can cut this piece of wire with the foil.

Touch the tip of the solder to the tip of the soldering iron to create a small pool of liquid solder on the irons tip. Starting the soldering task and as I told we need first to set the soldering iron tip and then we heat it up once its ready to use you can notice that the soldering wire is molten easily. It helps to start the heat transfer by dabbing the solder at the point where the iron and wires meet then move the solder.

Hold it on the wire for 3-4 seconds. Too much or too little flux will cause problems with the solder attaching to the parts. If there is clumping or excess solder you can reapply the iron to melt the solder.

Diameter of copper core. In this you have to use a soldering iron and melt the solder into the filaments. For tools Matt uses his trusty auto-stripper and an affordable soldering iron.

Make sure your soldering iron is fully heated and touch the tip to the end of one of the wires. The solder jar is made up by approx. Using the soldering gun heat the wiring up enough to melt the solder and gently apply the soldering to the wire with the soldering gun touching the wire.