How To Make Soldering Iron Wire At Home
Do it as shown in the photo.
How to make soldering iron wire at home. As shown in fig no. Take the copper tip 1 a piece of 710 cm of 345 mm diameter copper rod and roll the insulator over it on about 4 cm. The two irons are coupled together using a simple 3D printed part.
Now attach a long wire with the iron rod the cover the iron rod with a paper and tape it. Make sure you follow the instructions on the specific iron for temperature settings and proper usage. Ensure you make very close turns but the.
Then make two more bends near the center or loop of the first bend as shown in the video so the wire looks kind of like a z. Steps in Making a Soldering Iron. Make sure that the wires to be soldered are perfectly clean.
When soldering there are a few. You have successfully transformed your battery-powered soldering iron into a USB soldering iron. If it is present in the bad condition there would be no use at all to solder a good joint.
Then add a tiny bit of new solder to the wire. This handheld tool heats up to melt the solder around the copper wiring. Heat the wire until the whole joint melts together.
At this point plug the usb cable into a computer or usb wall outlet and ensure you have a good working connection. Make a heater resistor by attaching one end of heater nichrome wire of 03 to 05 mm in diameter and winding it over the insulator. Make sure that you twist them firmly.