How To Make Soldering Iron Tip
Take care not to over-tighten the locking nut beyond hand tight.
How to make soldering iron tip. Apply soldering flux to the tip often to prevent it from oxidization. If so you can do it with a normal soldering iron. This is done using a soldering iron.
Melt some good quality of solder wire on the Tip. Be sure that the soldering iron tip is held in the horizontal to the sensor with minimal movement to maximize physical contact between the middle of the working surface of the tip and the sensor. Wipe OFF the solder on the Cleaning Sponge or Copper Wool.
If you see any solder splashes after just flick it off with you finger nail not the soldering iron. Wipe the tip of the soldering iron on a damp wet sponge to clean it. Use sponge soaked in water to wipe the tip clean regularly.
How to Tin or Re-Tin Soldering Iron Tip. So you get what you paid for. Your soldering iron tip.
This prevents oxidation and corrosion. Switch OFF the Soldering Station or the Iron. When using the iron keep a little solder on the tip when the iron is in the stand.
Wait for a minute or two to melt the solder. Insert your prepared tip into the soldering iron. Hold it by the wire for 3-4 seconds.