How To Make Solder Stick To Tip

This is much like aluminum aluminum oxides and stainless more chromium oxides.

How to make solder stick to tip. Also heat the wire first and then apply solder to the area with the tip heating both the solder and the wire at the same time. This is where I suggest using my next soldering tip. It takes practice and then apply solder form the opposite side of where the tip is making contact.

If applied evenly this will keep the irons heat flow in check when it is next used in addition to preventing rust accumulation. A thin layer around the tip which provides the better transfer of heat from the tip to the solder joint. Press the blob of solder into the metal to be soldered.

Tip temperature also causes physical changes to the tip through the natural thermal expansion and contraction the metal undergoes during normal use. The bursh-in-bottle type is perfect. Initially the solder wont be too keen but when the metal reaches the right temperature the solder will suddenly be attracted to it and youll see it move slightly.

Touch the seam so that the ball sticks to the solder seam Continue along making the balls as close or far apart as you like. Clean the soldering tip after every hole to remove Excess Solder. Now simply melt a small ball of 6337 solder over one of the seams until it forms a little ball.

Holding the solder in one hand and the iron in the other briefly touch the solder to both sides of the tip. Good luck wetting stainless too. Just bought a soldering iron just to do this and have no experience so any tips would be appreciated.

Turn on your soldering iron and let it heat up. If it is present in the bad condition there would be no use at all to solder a good joint. Use liquid flux on the bare wire terminal.