How To Keep Soldering Tip Clean

You should not have to do more than periodically wipe the tip clean with a damp sponge then re-tin with fresh solder.

How to keep soldering tip clean. Wipe OFF the solder on the Cleaning Sponge or Copper Wool. Copper is used because its an excellent heat conductor but if exposed to solder it will quickly dissolve into the solder. Brass wool is softer and less abrasive while the harder stainless steel wool has a longer life.

When you are done for the day simply wipe clean as the iron is cooling and it will be ready to go the next time. Use pliers to keep the start of the solder at place. Metal wool effectively removes dirt and other contaminants and avoids issues associated with using a.

Cover the tip immediately with solder after cleaning to prevent further oxidation. Do Not Use any Scrub Sponge Used to Clean Utensils to Clean the Soldering Tip. It will wear and tear the tip and will damage it.

When pre-cleaning is necessary for plated tips they should be cleaned with a mildly abrasive emery cloth and may require an acid flux to remove the oxides before tinning or re-tinning. Melt some good quality of solder wire on the Tip. The tips are mostly copper with a protective iron plating and once that plating is pierced the tip will die quickly.

Then immediately re-tin the tip with rosin core solder. Use fluxes Spongeless and metal wool to remove small amounts of contaminants from your soldering iron tips during soldering circuit board or any other components. Wipe the iron on a damp sponge to remove the excess.

If some of the oxides are just sticking really well you could try to mildly abrade them on a brass sponge copper braid or similar but you cant be too hard or you will damage the iron plating good tips are typically copper core plated with iron then chromium everywhere but the. You can dampen it somewhat but keep any water drips away from the electrics. Then dip into the tin of tinner cleaner with a slight twisting action.