How To Clean Solder Iron Tip

It took a lot of effort with tip tinnercleaning compound to make the solder wet the tip again.

How to clean solder iron tip. Apply a bit of new solder so that all surfaces are coated. Once the re-tinning product melts around the tip hold it for several seconds and then clean the tip using dry cleaning methods like brass wool or an automatic. Try not to leave the iron sitting hot on the bench while not in use.

This will remove any oxides are in the tip. To apply the tip cleaner first heat the soldering iron. Use stainless steel wool flux and thick clothe to clean the tip.

Once clean and shiny perform tinning and now your tool is ready to use. Wipe OFF the solder on the Cleaning Sponge or Copper Wool. Heat your soldering iron up to the low end of a typical work range generally between 280 and 320C.

Melt some good quality of solder wire on the Tip. Be careful not to over-tighten the locking nut. The flux in tip cleaner removes the oxidation and build up from the soldering iron tip and then the solder re-tins the tip ready for use.

How to Tin or Re-Tin Soldering Iron Tip. Leave it there until the paste melts around the tip. If some of the oxides are just sticking really well you could try to mildly abrade them on a brass sponge copper braid or similar but you cant be too hard or you will damage the iron plating good tips are typically copper core plated with iron then chromium everywhere but the.

This step will coat the iron in a mixture of flux and solder. When doing this I clean my tip regularly removing excess solder to improve soldering. Push the soldering iron tip into the chemical cleaner until the entire rusted area is submerged.