How To Clean Brass Pipes

After soaking and scrubbing your pipe youll need to dry and buff it.

How to clean brass pipes. You can order them here. The best way to clean a one hitter pipe is to soak it in Isopropyl alcohol mixed with salt in a plastic bag or container for 30-60 minutes or overnight for the best results. Replace screen and rubber mouthpiece as needed.

Another option is to make a paste of equal parts salt flour and white vinegar. Put pipe back together. Turn that 2 copp.

Turned the main water supply off and went to remove the old shut off. Apply the paste to the brass and let sit for up to an hour. Step 1 Remove the screen.

Remove the paper towels and rinse off the vinegar. Use a pair of tweezers to gently remove the screen from your pipeStep 2 Inspect the screen. Heat the fitting and use a cloth to wipe the fluid solder out of the socket.

To remove any remaining ash or resin insert your pipe cleaner or brush into the shaft of the metal smoking pipe and scrub until gone. If you do not clean it then there is a possibility the surface will oxidize and make the fitting weak. When it is hot slamming it.

Spread soldering flux on the outside of the pipe and the inside of the brass fitting with a small brush. When you are satisfied that the paper towel is saturated through with vinegar you can then wrap the affected area of the copper pipe with it. Wring out the cloth so its only slightly damp and gently wipe the brass surface clean.