How Do I Use A Woodworking Router

If possible use the same wood and bit youll be using on your project.

How do i use a woodworking router. For instance if you have a broken table or other piece of wood you can use the router to trace the outline of the original piece and re-create it as many times as you like. Next install the pin board into the template and use a straight router bit to cut the pins. The most basic and primary use of a wood router is cutting holes in wood or routing out to hollow out a hole in a piece of wood metal or plastic while still producing finished edges cutaways curved contours and precisely measured holes.

When using a router always make sure you feed your router from left to right this will make sure the blade of the cutter makes correct contact with the wood being machined. Pull the trigger and push downward while holding the router with both hands. So when running the router along the outside edge of a boardfor example around the outside edge of a picture frameyou should cut counterclockwise or running from left to right.

Ahead learn the basics of handling this workshop staple like a veteran and get top tips on how to use your. Also make sure to work with the router in a counterclockwise direction around the top of the workpiece. Many of these units will just attach to a stationary part of your router.

This act will engage the bit with the wood. Rather than cutting with a router bit which can sometimes be too powerful a laser is used to burn thru the material. These routers will accept 14 shank as well as 12 shank bits and are often available with multiple bases see Combination Kits below.

Almost as important is knowing which bit to use for each woodworking application you attempt. The old adage use the right tool for the right job never applied more appropriately than when referring to this versatile tool. You can also use it to draw and inscribe wording onto a piece of wood as well.

How to properly use a woodworking router can save a lot of wasted wood and a lot of headaches not to mention it is a lot safer than not knowing how to use it correctly. Many router kits include a single motor that can be interchanged between a pair of bases for versatility. You clamp the tail board into the template and then use a dovetail router bit to cut the tails.