Correct Way To Solder Wires

Electrical connections should be made by splicing wires together in a way that keeps the current flowing through the joints.

Correct way to solder wires. You need to apply the heat to the metal part on the plug because that takes the longest to heat and melt the solder. Once the connection evenly turns the correct silver color of solder remove the soldering iron and allow the joint to cool. Some say its better to joint the two wires using a Y-splice while some only swear by the good ol rat tail splice.

How To Solder Wires. Hold the two tinned wires on top of each other and touch the soldering iron to both wires. Its vital to use a soldering iron that brings the wire up to temperature quickly.

This process should melt the solder and coat both wires evenly. Apply enough solder so that every strand of wire is surrounded by solder. Also doesnt leave an unsightly bulge under the heatshrink.

Carve a groove on each side of the 20x40 sides of the wood it should be enough so that the rods fit through the groove. Once cool inspect the union to ensure proper penetration of the solder. Tin the tip of the iron and then clean it with a sponge before heating the wire.

Correct procedure for soldering 2 wires together. It offers the lowest resistance and the best vibrationfatigue protection. Your basic average student will be working with through-hole PDIP packages hence gauges that work well are 18 20 and 21.

If your re-wiring your car or truck then this is a MUST Video For YOU. Run wires through grooves and make sure the rods stick out by 10mm at bottom of piece of wood. If you did the cable and the tag at the same time by the time the solder properly melted the wire insulation would have started to melt.