Can A Router Table Be Used As A Jointer

Can I use a router table as a jointer.

Can a router table be used as a jointer. Yes a very narrow jointer good for edge joining but too narrow for face jointing. By clamping a piece of plastic laminate on the left-hand outfeed end of the fence you can add an edge-jointing function to your router table fence. Feed it into the router just as you would when using a jointer.

Yes a very narrow jointer good for edge joining but too narrow for face jointing. You CAN joint on a router table but it isnt always the best choice especially with thicker lumber. It is a money-saving alternative to a dedicated pivotal jointer.

Photo 3 Photo 4. Router tables with a split fence can be great for edge jointing short pieces. Yes although there will be limitations to board depth based on bit size.

If your fence is 20 long then I would recommend jointing stock up to 36 or 13 longer than your fence. Heres the answer courtesy of our friends at the Woodworkers Journal. Place your laminate piece at the left-hand edge of the bit-clearance notch in the router table fence.

A jointer is made for that purpose and far more powerful and faster with the ability to take a bigger cut of wood than a router bit. The router is good for MANY things partucularly creating detail in lumber in a wide variety of profiles and joinery work are two of the areas it excels in. Furniture maker Gregory Paolini demonstrates a technique for jointing wood on the router table.

The only difference is that we have the board laying down rather than standing up as on a true jointer. Make sure your infeed and outfeed guides are long enough and rigid enough then you can set it up like a jointer layed on its side. Take note of the spacing between the edge of the bit and the outer edge of the bushing.